CCTV survey: $300–$750
Stands alone and is credited against the works by most operators. Without it nobody can price a liner honestly.
No-Dig Drain Repair
No-Dig Drain
Repairs In
Point Piper
We camera the line first, show you what is actually wrong, and then tell you whether relining is the right answer. Often it is. Where the pipe has collapsed or lost its fall, it is not, and we will say so rather than sell you a liner that disappoints.
- Licence 368473C, fully insured
- Before and after footage, yours to keep
- We say so when digging is the better answer
When A Liner Is The Right Repair In Point Piper
The failure that brings most people here is not a broken pipe. It is a joint. Older drainage is laid in short lengths, so a single run has a great many joints, and after decades of ground movement and root pressure they open a fraction at a time until something backs up.
A liner seals all of them in one pass, which is why it changes the pattern rather than resetting it. Cutting roots out clears the pipe and leaves the way in exactly as it was, and the interval to the next blockage is set by how fast they grow back.
Digging near the water is the expensive option
Excavation close to the foreshore brings problems that have nothing to do with plumbing: unstable saturated ground, dewatering, restricted access down a narrow lot, and reinstatement of landscaping that was not cheap to build.
The trenchless comparison is not repair against repair. It is repair against repair plus everything sitting on top, and on a waterfront block that second half is usually the bigger number.
Fall, bellies and what a liner cannot fix
This is the honest limit of the method. A liner follows the pipe it is cured inside. If the run has sagged into a belly or lost its fall, relining seals it and leaves the shape exactly as it was, so the water still pools where it pooled before.
Steep streets falling toward the water funnel stormwater fast, and blocked pits and lines back up in heavy rain. We clear them and keep them flowing.
On sloping ground that failure mode is common enough to check for specifically. Where the profile is wrong, the correct answer is excavation and re-lay of that section, and we will tell you so even though it is the more expensive quote.
Why earthenware is the ideal host for a liner
Many of Point Piper’s established residences still run on original clay and earthenware drains prone to cracks and sags. CCTV shows us the full picture.
Clay is rigid, round and predictable, and that geometry is exactly what a liner wants. The resin sleeve cures hard against a barrel that holds its shape, and the short pipe lengths that make clay joint-heavy are the same joints the liner seals in one pass.
So the material that causes the most recurring blockages in older streets is also the easiest to repair properly without digging. That is a genuinely lucky combination and it is why relining suits this housing stock so well.
Groundwater going the wrong way
An open joint leaks in both directions. On a low-lying block that means stormwater and groundwater entering the sewer through cracks, which is called infiltration, and it quietly overloads a line that would otherwise cope.
It shows up as a system that backs up in wet weather and behaves perfectly in dry. If that is the pattern, sealing the run is the fix, and no amount of clearing will reproduce the result.
Ground that moves, joints that open
Harbourfront properties cop constant salt air that corrodes ageing pipework and joints over time. A camera pinpoints the trouble spots.
Ground near water holds more of it, sits lower and moves more through the seasons than ground further up. Pipework laid decades ago has been flexed by that movement for its whole life, and joints open a fraction at a time rather than failing all at once.
It is why faults here tend to arrive as a slow decline rather than a sudden break, and why a camera often finds a run that is uniformly tired instead of one obvious defect. That pattern suits a full-length liner rather than a patch.
Joints, not pipe: what is actually failing
On a clay line the barrel is usually fine. What has gone is the mortar or rubber ring at each joint, and there is one every few hundred millimetres, which is a great many small openings after sixty or eighty years in the ground.
That matters for the quote. You are not replacing a pipe, you are sealing a long series of joints, and a liner does the whole run at once rather than patching them one at a time.
What it costs in Point Piper
Relining, $500–$900 per metre
The usual Sydney range for domestic sewer. Access and junction reinstatement are normally quoted separately.
Patch repair, $1,500–$4,000
One defect in an otherwise sound run. The proportionate answer on stable ground, and the wrong answer on a line with twenty tired joints.
Full domestic run, $6,000–$15,000
Where the camera shows the same failure repeating along the length. Ends the problem rather than relocating it.
Excavation, from $2,500 plus reinstatement
The honest comparison. Cheaper on an open lawn, rarely cheaper under a driveway, paving or a building.
Indicative Sydney ranges for 2026. Your job is quoted in writing after the camera survey. Figures here are indicative of the 2026 Sydney market rather than a quote from us, you get your own number as a fixed price before any work starts.
From Survey To Finished Liner
Step 01
Step 01
Survey And Measure
We find the fault, measure it from an access point, and check the fall is intact. That last check is what stops a liner being installed into a belly.
Step 02
Quote In Writing
Per metre, with access and junction reinstatement itemised, and the excavation comparison alongside it so you can see both.
Step 03
Reline It
Clean, install, cure. One access point, one day for most homes, and no trench across the property.
Step 04
Hand It Over Documented
Branches reopened, final footage, certificate and notification. Keep it with the property file, it is worth real money at sale.
Not Sure If It Needs Relining At All?
Describe what the drain is doing and how often. We will tell you whether it sounds structural or whether a clean and a maintenance interval is the honest answer.
Pipe Relining Questions
Cost, lifespan, method, and the cases where a liner is the wrong answer.
Relining is priced per metre and the range across Sydney in 2026 is roughly $500 to $900 a metre for a domestic sewer, with junction reinstatement and access usually quoted separately. A short patch repair over a single defect commonly lands between $1,500 and $4,000, and a full-length domestic run more often sits between $6,000 and $15,000. The honest comparison is not liner against nothing: it is liner against excavation plus reinstating whatever sits on top of the pipe.
Usually, but not always, and anyone who says always is selling. Relining wins wherever something valuable sits above the pipe: a driveway, established garden, paving, a building, or trading days you cannot afford to lose. Excavation wins on an open lawn with a shallow line, and it is the only answer where the pipe has collapsed, lost its fall or been crushed out of round. A camera survey is what tells you which case you are in.
Most domestic relining is a single day on site: set up at an existing access point, jet and camera the line clean so the liner bonds to pipe rather than debris, install, cure, then reinstate the junctions and camera it again. Water is off for part of the day. Larger or commercial runs are staged, and are often scheduled overnight or across one closed day so the premises can trade.
Yes, though slowly. Ground near water holds more of it, sits lower and moves more through the seasons, so pipework has been flexed for its whole life and joints open a fraction at a time. Faults here arrive as a gradual decline rather than a sudden break, and a camera often finds a uniformly tired run instead of one obvious defect.
Usually much better, because excavating on a slope is a different job from excavating on the flat. Machine access is often impossible, spoil has to go somewhere, trench walls need support, and reinstating a tiered garden or retaining structure can cost more than the drainage work itself. A liner is installed from an existing access and leaves the surface untouched.
Often yes, and that surprises people. A well laid clay line of that age usually still has a sound barrel; what has gone is the mortar or rubber at each joint, and there is one every few hundred millimetres. You are sealing a long series of small openings, not replacing a pipe, and that is exactly what relining is for.
It is groundwater and stormwater entering the sewer through cracks and open joints, and it matters more than most people expect. It quietly overloads a line that would otherwise cope, which shows up as a system that backs up in wet weather and behaves perfectly in dry. If that is your pattern, sealing the run is the fix and clearing will never reproduce it.
Book A Relining Survey In Point Piper
Ring us or leave your details. You will get a time for the inspection, not a price invented over the phone.
